Research Development Manufacturing Operations Maintenance Management
Scindeks Assistant Scindeks Assistant — A system for serious journals and those aspiring to become one
Vol. 15 No. 3 (2017)
Vol. 15 No. 3 (2017)

FINE TURNING OF THE VEHICLE FORMED COMPONENTS COATED BY THE ULTRA-HARD POLYCRYSTALLINE TOOLS

DOI: 10.5937/jaes15-12834
Klimenko Sergey Anatolievich
Klimenko Sergey Anatolievich, Bakul Institute of hard materials of NAN of Ukraine, Kiev
Trofimov Igor Leonidovsch
Trofimov Igor Leonidovsch, National Aviation University. Ukraine, Kiev
Burykin Vitaliy Vitalievich
Burykin Vitaliy Vitalievich, Bakul Institute of hard materials of NAN of Ukraine
Prymak Liudmyla Borysivna
Prymak Liudmyla Borysivna, National Aviation University. Ukraine, Kiev
Ljubodrag Tanović
Prof. dr Ljubodrag Tanović University of Belgrade, Faculty of Mechanical Engineering
PDF

Published

2017-09-15

Section

Original Scientific Paper

Abstract

The questions treatment cutting of the shaped details are considered with chromium-nickel coatings by lathe instruments, equipped polycrystalline ultra hard materials on the basis of cubic boron nitride of the coniferous forest. The features of technologies of lathe treatment of details are rotined with coverages at the improvement of structural descriptions of cutting plate, technological parameters of process of cutting and coverages on an instrument. It is set that application of sheeting allows to promote firmness of polycrystalline instruments on the stage of earning extra money due to diminishing of adhesive contact between the processed and instrumental materials.

Keywords

Array
Array
DOI: 10.5937/jaes15-12834

References

Autori koji objavljuju u ovom časopisu pristaju na sledeće uslove:

  1. Autori zadržavaju autorska prava i pružaju časopisu pravo prvog objavljivanja rada i licenciraju ga Creative Commons licencom koja omogućava drugima da dele rad uz uslov navođenja autorstva i izvornog objavljivanja u ovom časopisu.
  2. Autori mogu izraditi zasebne, ugovorne aranžmane za neekskluzivnu distribuciju rada objavljenog u časopisu (npr. postavljanje u institucionalni repozitorijum ili objavljivanje u knjizi), uz navođenje da je rad izvorno objavljen u ovom časopisu.
  3. Autorima je dozvoljeno i podstiču se da postave objavljeni rad onlajn (npr. u institucionalnom repozitorijumu ili na svojim internet stranicama) pre i tokom postupka prijave priloga, s obzirom da takav postupak može voditi produktivnoj razmeni ideja i ranijoj i većoj citiranosti objavljenog rada (up. Efekat otvorenog pristupa).

Downloads

Download data is not yet available.