Abstract
The authors obtained dependencies of the surface layer properties after machinig cylinder holes by vibroburnishing. The properties of the surface layer are changed from a variety of vibroburnishing factors. Surface layer quality graphics of the machining parameters are obtained by mathematical modeling using formulas derived empirically.
During the processing of experimental data, the authors of the articles identified optimal processing regimes in which parameters of the quality of the surface layer of the billet can be specified. Thus, vibroburnishing is better to make machining on the mode: m = 16,5 mm, i = 1,7 mm, α = 7,5 °, Ay = 160 J, ƒ = 20 Hz.
It was found that the greater vibroburnishing tightness is, the greater the value of size of the cold-hardening layer is. Rougher surface will always have bigger tightness of burnishing, i.e. the purer surface is, the lower the value of tightness of a vibroburnishing must be. However, in the process of a vibrational burnishing of holes there is a so-called critical point, roughness of a surface decreases and the surface layer of metal is strengthened before reaching this point, and after reaching it there is a phenomenon of a re-cold-hardening and quality of a surface decreases.Keywords
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
Array
DOI:
10.5937/jaes16-13860
References
Autori koji objavljuju u ovom časopisu pristaju na sledeće uslove:
- Autori zadržavaju autorska prava i pružaju časopisu pravo prvog objavljivanja rada i licenciraju ga Creative Commons licencom koja omogućava drugima da dele rad uz uslov navođenja autorstva i izvornog objavljivanja u ovom časopisu.
- Autori mogu izraditi zasebne, ugovorne aranžmane za neekskluzivnu distribuciju rada objavljenog u časopisu (npr. postavljanje u institucionalni repozitorijum ili objavljivanje u knjizi), uz navođenje da je rad izvorno objavljen u ovom časopisu.
- Autorima je dozvoljeno i podstiču se da postave objavljeni rad onlajn (npr. u institucionalnom repozitorijumu ili na svojim internet stranicama) pre i tokom postupka prijave priloga, s obzirom da takav postupak može voditi produktivnoj razmeni ideja i ranijoj i većoj citiranosti objavljenog rada (up. Efekat otvorenog pristupa).
Downloads
Download data is not yet available.