Abstract
In this research, (12) normal reinforced concrete beams are used with dimensions (110*10*20) cm, the compressive strength for all specimens is 30 MPa. Longitudinal steel is deformed bars 2Ø12mm with Ø6 mm transverse reinforcement which is deformed bars also for different spacing 5 cm, 10 cm and 15 cm. After casting the specimens and removing them from the molds, they left for about 28 days. They tied by CFRP strips with different shapes of tying (tied, inclined and X- shaped). They are all testing with two points load by a hydraulic machine for determining (Pu, P cr, maximum deflection and modes of failure) and compared among their results with the specimens without CFRP strips. From the experimental program, the excellent behavior of the specimens with the X-shaped strips especially with the Pu which is 70% increment and maximum deflection is 39% decrement. The addition of CFRP strips as a tying material helps to increase the strength of concrete and bearing against loads also, changes and decreases the flexural and shear failure and combined failure.
Keywords
Array
Array
Array
References
Jumaat, M. Z., Rahman, M. M., & Alam, M. A. (2010). Flexural strengthening of RC continuous T beam using CFRP laminate: A review. International Journal of the Physical Sciences, 5(6), (pp. 619-625).
Khalifa, A., & Nanni, A. (2002). Rehabilitation of rectangular simply supported RC beams with shear deficiencies using CFRP composites. Construction and Building Materials, 16(3), (pp. 135-146).
Bukhari, I. A., Vollum, R. L., Ahmad, S., & Sagaseta, J. (2010). Shear strengthening of reinforced concrete beams with CFRP. Magazine of Concrete Research, 62(1), (pp. 65-77).
Asad ur Rehman Khan, Shamsoon Fareed, (2014). Behaviour of Reinforced Concrete Beams Strengthened by CFRP Wraps with and without End Anchorages. Fourth International Symposium on Infrastructure Engineering in Developing Countries, IEDC. Procedia Engineering 77 ( 2014 ) 123 – 130.
B. Srudhira, M. Anil kumar, K. J. Brahma Chari, (2019). Evaluation of Shear Behaviour of RC Beams Using CFRP. International Journal of Recent Technology and Engineering (IJRTE) ISSN: 2277-3878, Volume-7, Issue-6C2, April 2019.
BS882. 1992. ”specification for aggregate from nurture source for concrete.”(December 1992).
- Autori zadržavaju autorska prava i pružaju časopisu pravo prvog objavljivanja rada i licenciraju ga Creative Commons licencom koja omogućava drugima da dele rad uz uslov navođenja autorstva i izvornog objavljivanja u ovom časopisu.
- Autori mogu izraditi zasebne, ugovorne aranžmane za neekskluzivnu distribuciju rada objavljenog u časopisu (npr. postavljanje u institucionalni repozitorijum ili objavljivanje u knjizi), uz navođenje da je rad izvorno objavljen u ovom časopisu.
- Autorima je dozvoljeno i podstiču se da postave objavljeni rad onlajn (npr. u institucionalnom repozitorijumu ili na svojim internet stranicama) pre i tokom postupka prijave priloga, s obzirom da takav postupak može voditi produktivnoj razmeni ideja i ranijoj i većoj citiranosti objavljenog rada (up. Efekat otvorenog pristupa).