Abstract
In steel structures, the I-beams are in many cases exposed to combination of bending moment and bimoment actions. In the elastic stage of work, material strength check is based on maximum normal stresses, which for symmetric I-beams are the sum of moment and bimoment stresses. The maximum stresses are compared with calculated resistance. In both European codes and Russian standards for design of steel structures, calculation of members is performed considering the conditions in which the plastic deformations over the section are allowed. With the development of plastic strains, bearing capacity of section is higher than in the elastic stage. The existing normative documents for the design of steel structures in Russia do not include design coefficient taking into account development of plastic deformations in warping torsion. The article examines combined action of bending moment and bimoment on I-beam profiles throughout the theoretical and numerical solutions. Recommendations for checking their bearing capacity in accordance to Russian standards are given, taking into account development plastic deformations.
Keywords
Array
Array
Array
Array
References
- Autori zadržavaju autorska prava i pružaju časopisu pravo prvog objavljivanja rada i licenciraju ga Creative Commons licencom koja omogućava drugima da dele rad uz uslov navođenja autorstva i izvornog objavljivanja u ovom časopisu.
- Autori mogu izraditi zasebne, ugovorne aranžmane za neekskluzivnu distribuciju rada objavljenog u časopisu (npr. postavljanje u institucionalni repozitorijum ili objavljivanje u knjizi), uz navođenje da je rad izvorno objavljen u ovom časopisu.
- Autorima je dozvoljeno i podstiču se da postave objavljeni rad onlajn (npr. u institucionalnom repozitorijumu ili na svojim internet stranicama) pre i tokom postupka prijave priloga, s obzirom da takav postupak može voditi produktivnoj razmeni ideja i ranijoj i većoj citiranosti objavljenog rada (up. Efekat otvorenog pristupa).